Leading Manufacturer for Formwork For Concrete Column - Wall & Slab Plastic formwork – Zhongming

ABS PLASTIC FORMWORK ADVANTAGES:

1.LIGHT
Lighter  panels are safer, easier to use and more productive. It is a fact that repeated lifting of heavy equipment causes fatigue and injury. Zhongming plastic formwork weighs on average 17 kg/m2 with no single element heavier than 13 kg: this means that the whole system can always be used by hand, in any situation. Crane operation is not a must anymore, giving construction sites much greater flexibility without any compromise on health and safety

2.FAST
doing the job with as few components as possible. Low weight and simplicity improve the speed of use.

3.STORAGE
Moisture and water will not affect the panels in any way, dry storage conditions are not necessary

4.STRENGTH
ABS is a very strong polymer, impact and abrasion resistant. Zhongming plastic formwork resists to a pressure of up to 60 kN/m2.

Property and Characteristics:

1. Weight: About 15KG/Square Meter

2. Material:  ABS plastic, or PP+glass fibres, Nilon,

3. Composition: Panels, corners, handle and accessories

4. Resued: over 100 times

5. Waterproof: Yes

6. Eco-friendly: Yes

7. Thermal deformation temperature: Above 150 degree Celsius

8. Assemble and disassemble:Easy and quick

9. Certification:CNAS Test

Main size：

1.Wall panel :1200*600mm,100*600mm, 200*600mm,250*600mm, 600*10mm,600*20mm

2.Corner:inner corner 200x200x600mm and outer corner 100x50x600mm

3.Square Column:750*730*70mm(thickness of wall can be adjusted from 200- 600mm with per 50mm increment)

4.Round Column:750*400mm,750*300mm

Application:

For concrete wall, slab, columns 

Material and Structure

1.Material:PP+glass fibres+Nilon

2.Structure：panels, corners, handle and accessories

Feature

1.Long lifespan& Cost effective –The experiment shows that our Plastic Formwork can be reused over 100 times, while the Plywood can only be reused 7 to 10 times. Therefore the Plastic Formwork increases the cost efficiency.

2.Waterproof – For the nature of plastic material, this item is a kind of anticorrosive material, especially suitable for underground and watery circumstances.

3.Easy reassembly– It is easy for worker to operate and split.

4. Pouring expediently– The template will be separated easily from concrete.

5.Simple Installation – the mass of the product is light, at the same time it is safe to handle and easy to clean.

6.High Quality –it is hard to deformation.

7.Recyclable — Waste scrap molding board could be recycled.